Kminiak, Richard, 1984- Influence of the thickness of removed layer on the quality of created surface during milling the MDF on CNC machining centers / Richard Kminiak, Adrián Banski, Dmitry K. Chakhov. -- Obr., tab. -- Lit - The article deals with the issue of MDF boards milling on CNC machining centers. Specifically , there is analyzed the dependence of roughness of created surface on the change of the layer thickness of removed material . The a rticle is based on an experiment which follows milling of 18mm thick MDF board at the 5 ax is CNC machining center using a miller with one reversible blade and then a miller with two reversible blades . The experiment is performed at the intervals recommended by manufacturer regarding cutting and feeding s peeds and machining strategies . The roughness of created surface is presented by a parameter - arithmetic mean deviation of the surface roughness Ra. The article highlights the fact, that thickness of removed material layer does not have a statistically significant influence on the surface r oughness. At the same time, it points out the fact that there is not the same dependence of the roughness of created surface on the nominal thickness of the chips during milling of the MDF boards , as we would expect on the basis of general assumptions.

In Acta Facultatis Xylologiae Zvolen : vedecký časopis Drevárskej fakulty. -- Zvolen : Technická univerzita vo Zvolene, 2017. -- ISSN 1336-3824. -- Roč. 59, č. 2 (2017), s. 137-146

I. Banski, Adrián, 1975-
II. Chakhov, Dmitry K.
III. Acta Facultatis Xylologiae Zvolen : vedecký časopis Drevárskej fakulty. -- Roč. 59, č. 2 (2017), s. 137-146

630*862+539.211+621.9.02
ZV001