Kminiak, Richard, 1984- Granulometric analysis of chips from beech, oak and spruce woodturning blanks produced in the milling process using 5-axial CNC machining center / Richard Kminiak, Adrián Banski. -- Obr., tab. -- Lit. - Granulometric composition of chips resulting from the milling process of beech, oak and spruce woodturning blanks with the thickness of 25mm usinga single milling cutter and a CNC machining center SCM TECH Z5 is presented in the paper. Granulometric composition of chips is observed in the range of commonly used technological conditions for given type of the milling cutter such as feed rate vf= 1 to 5 m·min-1 and the thickness of removed layer e = 1, 3 and 5 mm. The fact that more than a half of the produced chips is a coarse fraction of fibrous chips with dimension more than1 mm can be stated following the granulometric analysis. Isometric grains, i.e. chips with approximately the same size in all three dimensions are formed from dust fractions smaller than 500 μm. There is, on average, 2.38 % of inhalable dust with particles smaller than 125 μm. The finding that no particles in respirable dust with the size smaller than <10 μmare formed can be stated.

In Acta Facultatis Xylologiae Zvolen : vedecký časopis Drevárskej fakulty. -- Zvolen : Technická univerzita vo Zvolene, 2019. -- ISSN 1336-3824. -- Vol. 61, no. 1 (2019), s. 75-82

I. Banski, Adrián, 1975-
II. Acta Facultatis Xylologiae Zvolen : vedecký časopis Drevárskej fakulty. -- Vol. 61, no. 1 (2019), s. 75-82
ZV001