Granulometric composition of chips and dust produced from the process of working thermally modified wood / Alena Očkajová ... [et al.]. -- Graf., obr. -- Lit. - The granulometric composition of chips and dust from the longitudinal milling and sanding of thermally modified oak and spruce wood over a set of modification temperatures: 160, 180, 200 and 220 °C is determined and differences between the factors affecting the granulometry during these two woodworking processes are defined in the paper. Sieve analysis yielded percentages on individual sieves. Residual curves were used to emphasize the difference in these technologies in the granulometric composition, where a shift to the left signals smaller (finer particles) or dust particles. While the sanding dust residue curves shift to the right due to the elevated temperature of the wood treatment, i.e. towards larger fine particles and medium coarse particles, the chip residue curves from the milling process shift to the left, with a higher share of medium coarse, fine and dust fractions due as the wood modification temperature increases.

In Acta Facultatis Xylologiae Zvolen : vedecký časopis Drevárskej fakulty. -- Zvolen : Technická univerzita vo Zvolene, 2020. -- ISSN 1336-3824. -- Vol. 62, no. 1 (2020), s. 103-111

I. Očkajová, Alena, 1961-
II. Kučerka, Martin, 1980-
III. Kminiak, Richard, 1984-
IV. Rogoziński, Tomasz
V. Acta Facultatis Xylologiae Zvolen : vedecký časopis Drevárskej fakulty. -- Vol. 62, no. 1 (2020), s. 103-111

630*82+630*812.14+630*823.1+613.633+504.3.054
ZV001