Assessment of wear of the bandsaw teeth in industrial conditions / Kazimierz A. Orłowski ... [et al.]. -- Graf. tab. -- Lit. - A methodology for measuring bandsaw tooth wear is presented in this paper. This type of measurement is proposed as an alternative way of determining tooth wear in industrial conditions. The method is based on determining the KE value, i.e., the distance of the radius of the rounded cutting edge of the tooth and the intersection of the surface of the back and the surface of the face of the cutting wedge of the bandsaw tooth. The rate of wear of bandsaw teeth is determined by comparing the measured value with the KE values given in the literature. During the development of the methodology, experimental cutting tests were performed at a sawmill that specializes in the production of floors from multi-layer glued laminated wooden boards. The investigated band saw was applied in the sawing process of oak (Quercus L.) boards. The average moisture content of the wood was MC = 32.9% when using the "wet" technology of lamella production. Since the monitored wear values are not very high, the use of certified measuring instruments is strongly recommended.

In Acta Facultatis Xylologiae Zvolen : vedecký časopis Drevárskej fakulty. -- Zvolen : Technická univerzita vo Zvolene, 2022. -- ISSN 1336-3824. -- Vol. 64, no. 2 (2022), s. 69-76

I. Orłowski, Kazimierz A.
II. Chuchała, Daniel
III. Stenka, Dawid
IV. Przybylinski, Tomasz
V. Acta Facultatis Xylologiae Zvolen : vedecký časopis Drevárskej fakulty. -- Vol. 64, no. 2 (2022), s. 69-76

630*822.34+621.935+630*81+674.093.6+621.93+630*822.1
ZV001